DCCP Conformance Test Suite

Home
Usage
Features
Test Reports
History
Downloads
FAQs
Developer's Notes

Hardware Requirements

TAHI's v6eval test tool must have two machine connect with eth device and serial device like the following:

                ________________________________________________
               | 3ffe:501:ffff:100:...    3ffe:501:ffff:100:... |
          ethX | 192.168.0.19                      192.168.0.21 | ethX
        _______|_______                                  _______|_______
       |               |                                |               |
       |      TN       |--------------ttySx-------------|      NUT      |
       |_______________|                                |_______________|
      
      

You can also run the test suite on vmware which has the same configure.

Software Requirements

pmake

The BSD 4.4 version of make. pmake supports some additional syntax which is not in the standard make program.

How to Install

1. Configure serial device On NUT

1). Add following line to /etc/inittab:
S0:2345:respawn:/sbin/mingetty ttyS0

2). Add following line to /etc/securetty:
ttyS0

3). Confirm serial device configure on TN:
#cu -l /dev/ttyS0

2. Install test suite on TN

1). install v6eval

      # tar zxvf v6eval-3.0.14-linux-dccp.tar.gz
      # cd v6eval-3.0.14-linux-dccp
      # pmake
      # pmake install

2). install dccpct

      # tar zxvf dccp-1.0.0.tar.gz
      # cd dccp-1.0.0
      # pmake install
      # cd /usr/local/v6eval/dccp
      # pmake configure

3. Test on TN

      # pmake clean v4test   ==> test under IPv4
      or
      # pmake clean v6test   ==> test under IPv6